Original Message: Practice for Fred’s marble |
---|
When Fred first approached me to drill his very large marble I knew that the most difficult thing would be getting the hole centered on each end. Fred’s marble measures 42.7 mm 1.68 inch I knew that the deeper you drill the more likely it is that the drill will wander. I had a marble that measured a bit larger than Fred’s 43.6 mm 1.71 inch that someone other than myself had reworked. I decided to do my trial and error on this marble in case I encountered any problems. I tried drilling from each end to the center and saw that this was not the way to go, but being committed I finished this marble’s first hole in this way and then started drilling in one direction only, in doing this I somewhat fixed an area where the drill went off center. I am going to wait until Fred has his new marble bead and has a chance to post it on BCN, once he does I will tell all that are interested just what I did to get Fred’s marble hole almost exactly in the center of each end. Below are images of my practice marble bead, it is very nice and I am sure there will be someone out there that will want to purchase it in the future. All my best ..................... Danny All rights reserved by Bead Collector Network and its users |
|